I was trying to create a line that slopes upwards in a form for example a line that starts on the left margin 1 inch (1440 twips) down and slopes upward to a position on the top. I tried setting the properties as follows:
Top = 1440
Left = 0
Width = 1440
Height = -1440
I get the error, "The control or subform is too large for this location"
I get this error if I set any of these properties to a negative value but how else could I produce this line. Does anyone know how to do this?
Top = 1440
Left = 0
Width = 1440
Height = -1440
I get the error, "The control or subform is too large for this location"
I get this error if I set any of these properties to a negative value but how else could I produce this line. Does anyone know how to do this?